Changing the Compatibility Settings

 

This will only change the view of your Realfast program, NOT the display settings of your entire computer.

  1. Be sure Realfast is completely closed while adjusting these settings.
     
  2. Right click on the Realfast icon and click on Properties.
     
  3. Click on the Compatibility tab at the top.
     
  4. Put a check mark where it says "Run in compatibility mode for".
     
  5. Start by selecting Windows 2000, and click Apply and then OK.
     
  6. Now go back into Realfast and see if it looks correct.
     
  7. If it doesn't look correct, repeat steps 1-6 until you've tried all four settings (Windows 2000, Windows NT, Windows 98, and Windows 95), and have found the one that looks the best.